
Good to know
Penkid Window Lock in Kyzylorda Fitted to Your Sash and Frame
We supply and fit Penkid window locks in Kyzylorda, matching each lock and its fixing to your profile, sash type and floor. A free measuring visit comes first, the fitter checks the hardware and picks the right fastener, and you pay only after installation by cash, card or Kaspi.
Which Penkid window lock suits your window and how to tell the types apart
A Penkid window lock is a family of devices with different logic. We start with what each does, then how you pick the right one for your sash.
What a Penkid window lock does on a sash and what it does not do
A Penkid window lock keeps a sash from being opened by a child, either by locking the handle or by limiting how far the sash swings, and it works alongside the existing hardware rather than replacing it. The mechanism sits on the sash or the frame and adds a second step before the window opens: a key, a tether or a fixed stop. It does not reinforce the glass, change the profile or turn a tilt-and-turn leaf into a sealed unit. What it removes is the easy pull a toddler reaches for at sill height. The device matters most on low first-floor windows and sashes next to a sofa or bed. Such a barrier buys time, so keep furniture away from the sill and the handle out of reach.
Blocker, cable restrictor or lockable handle and where each one fits
| Device | What it does | Best for |
|---|---|---|
| Blocker (Jammer type) | Holds the sash shut, key needed to release | Child's bedroom, low first-floor window |
| Cable restrictor | Lets the sash open a fixed distance on a tether | Balcony door, kitchen window used daily |
| Lockable handle | Replaces the handle, key locks the turn | Any sash where the handle is the weak point |
Matching a Penkid window lock to your profile, sash and floor
Compatibility is decided by the profile, the opening side and the floor, not by the lock model alone. Here is what to check before you order.
Will a Penkid window lock fit plastic, wooden and aluminium windows
- Plastic windows: Penkid locks fit PVC leaves, transoms and balcony doors, with fixings matched to the reinforcement inside.
- Wooden windows: the fitter checks the timber around the screw point first, since older frames can be soft near the edge.
- Aluminium windows: thin-walled profiles take shorter screws and sometimes a bracket instead of a direct fixing.
- Balcony doors and loggia glazing: the same devices work here, provided the panel swings rather than slides.
- Soft or hollow frames: the fixing moves a few centimetres to solid material, so the lock holds under pull.
Sash, frame or transom and how many locks one window needs
A lock goes on the movable section, not the fixed frame, and one lock per opening side is the usual rule. A two-panel window with a single active side takes one lock, while a tilt-and-turn unit needs a part covering both the turn and tilt position. On a fixed pane there is nothing to secure, so the device moves to the transom or door beside it. If the leaf sits on vent position and you want it held there, a restrictor is the right part rather than a blocker, which would force it shut. Count the movable sides first — that number, not the window width, sets how many locks the order contains.
Choosing for a top floor, a low floor or a window next to furniture
- Low floor facing a street or yard: a blocker with a key, since the drop is the main risk.
- Top floor with a fixed pane: a restrictor is often enough, as the gap is small.
- Window above furniture: a keyed blocker, because a child can climb to the tether.
- Balcony door used by adults: a restrictor that releases with a key for daily passage.
How the free measuring visit and the fitting work
Measuring and fitting can be one visit or two, depending on the device and window. Here is what happens at each step, from first check to fitter leaving.
What the measurer checks before any drilling
The measurer comes at a time that suits you, takes the sash and frame sizes, checks the hardware and the floor, and helps you choose the device, the fixing and the finish before anything is ordered. Measuring and consultation are free, and the measurer brings a tape, a level and samples of the fixings to compare on your own window. He checks the profile depth, the gap between leaf and frame and the handle position, because a blocker that fits a narrow casement will not sit the same way on a wide tilt-and-turn leaf. On upper floors he also notes the opening angle, since a restrictor must stop the leaf before it swings past the safe point. Ask him to show where the fixing will sit before drilling.
Drilling or no drilling and what happens to the window afterwards
Some devices clamp or replace the handle with no drilling, while a screw-on blocker needs two small holes, and the fitter tells you which case yours is before starting. A replacement lock uses existing screws, so the leaf keeps its factory holes. A cable restrictor anchors to frame and leaf, meaning two small fixing points rather than a full set. A screw-on blocker is the most solid option on a wide casement, and its two holes are hidden behind the unit while it stays on. If you may remove the lock later, choose a handle-replacement or clamp type — the leaf stays untouched, with nothing to patch when the unit comes off.
How long the visit takes and what to prepare
- Clear the sill and floor: around the window so the fitter can reach the leaf and open it fully.
- Have an adult at home: who can test the key and the release with the fitter.
- Note any furniture: under the window, so the device is placed out of a child's reach.
- Keep the key and the instructions: the fitter hands over at the end, with the warranty note.
Strength, winter care and keeping the lock working
A lock serves for years when not overloaded and looked after at the right moments. Below is what the hardware holds against and how to keep it turning freely through cold months.
What happens if a child pulls hard on the sash
A correctly fitted Penkid lock holds against a child's pull because the load goes into the leaf and frame through the mount, not into the key or handle alone. The hardware is chosen for the window profile: Z-brackets on a deep PVC rebate, plungers on a narrow aluminium section, magnets where drilling has to be avoided. Once the bracket is set, a sharp tug travels from the leaf into the frame and stops there, while the cylinder sees almost none of it. The weak point is rarely the device but a fastener set into a thin or damaged part of the profile, so the measurer checks the mounting point first.
Winter care so the lock does not seize
- Turn the key a few times each month so the mechanism does not sit idle in one position.
- Wipe condensation off the body after cold nights, before it freezes inside the cylinder.
- Lubricate the keyway with a single drop of lock oil rather than thick grease that stiffens in frost.
- Check the cable on a restrictor once a season for fraying, slack or a kink near the mount.
Ordering a Penkid window lock in Kyzylorda with payment after fitting
Ordering starts with a free measuring call and ends with payment once the device is fitted and working. Below is what our guarantee includes and how to reach us.
What the warranty covers on the lock and the fitting
We give a 1-year warranty on window repair, covering both the labour and the parts we replace, and the same terms apply to fitting a Penkid lock on your window. The period runs from the day the fitter finishes, so a lockable handle that stops latching or a cable restrictor with a stiff anchor is checked and put right within that time at no charge for work or parts. Our general window installation carries a 5-year guarantee and glass unit replacement 3 years. If you order a Penkid window lock in Kyzylorda, the warranty is tied to the order sheet the fitter leaves, which links the date and the item and speeds later service calls.
How to book a visit and pay after installation
How to book a visit and pay after installation You book a window lock fitting in Kyzylorda by messaging us on WhatsApp, where we reply within 5 minutes, and you pay after installation by cash, card or Kaspi. We work seven days a week, so a Saturday or Sunday appointment is normal, and the measurer comes at a time that suits you to take sizes and match the hardware to your profile. Payment is taken only once the lock is fitted and you have tried it, and the price is fixed in the order after measuring. Send a photo of the open leaf and the handle in the first message so we bring the likely part on the first trip.
How to choose a Penkid window lock to protect your window
A short recap of the points that matter most before you choose a model, book a visit or turn the key for the first time.
- Match hardware to the room , not price — a blocker suits a child's bedroom, a cable restrictor a balcony door adults use daily.
- One lock per opening leaf is usual, and a tilt-and-turn window needs a unit securing both swing and tilt.
- The fixing decides strength , so let the measurer check the profile and floor before drilling.
- Ask about drilling before the visit if you may remove the fitting later — clamp and handle types leave the frame untouched.
- Care stays simple — operate the key monthly, oil the keyway lightly, check a restrictor cable each season.















Limiters
Blockers
Key handles
Child safety
Ready-made screens