Apartment servicing
Full service cycle for all windows: adjustment, lubrication, drainage cleaning. Price from 6 600 ₸ per apartment.


Apartment servicing
Full service cycle for all windows: adjustment, lubrication, drainage cleaning. Price from 6 600 ₸ per apartment.

Seasonal adjustment
Switching sashes to winter or summer mode for a tight seal. Price from 3 000 ₸ per window.

Cleaning and lubrication
Cleaning dust from hardware and applying lubricant for smooth operation. Price from 1 250 ₸ per sash.

Seal care
Treating the rubber seal with silicone to keep it elastic. Price from 750 ₸ per linear metre.

Drainage holes
Cleaning drainage channels to drain moisture and prevent water pooling. Price from 3 600 ₸ per visit.

5,097 reviews on review sites
A set of works for hardware, seal and drainage care to extend window service life.
Servicing includes sash adjustment, cleaning and lubrication of hardware, silicone treatment of the seal, cleaning drainage holes and checking the tightness of joints.
A typical apartment set is 2–3 windows with 2–3 sashes each: in one visit the technician services all sashes, including tilt-and-turn ones, and checks every hardware unit.

per apartment
per sash
warranty on works
Switching hardware to the required sash pressure mode to keep warmth in winter and ventilate in summer.

The technician checks how tightly the sash fits, the condition of hinges and the operation of locking mechanisms.
The technician checks even pressure around the entire sash perimeter and determines from gaps and seal contact marks that the mode is set incorrectly.
Pressure should not be loosened on the ground floor or on the windy side — this accelerates seal wear and reduces protection from draughts.
If necessary, the handle or other components are replaced. Price from 2 750 ₸ per handle.
Five types of work with unit prices: from hardware lubrication to handle replacement and seal treatment.
per sash

Cleaning mechanisms from dust and applying lubricant for smooth operation.
per linear metre

Treating rubber with silicone to maintain elasticity and tightness.
per job

Removing blockages from drainage channels to drain condensation.
per unit

Installing a new window handle instead of a worn or broken one.
per sash

Applying sealant to joints to eliminate draughts.
Prices are per unit of work according to the price list; the total is calculated based on the number of operations performed.
| Type of work | Price |
|---|---|
| Comprehensive window servicingfull service cycle | from 10 000₸ per window |
| Window servicing for an apartmentall windows | from 6 600₸ per apartment |
| Seasonal maintenance (winter/summer)hardware mode switch | from 3 000₸ per window |
| Cleaning and lubrication of hardwaremechanism care | from 1 250₸ per sash |
| Cleaning and lubrication of sealsilicone treatment | from 750₸ per linear metre |
| Basic sash adjustment during servicinghinge tightening | from 3 000₸ per sash |
| Balcony door adjustmentsash setting | from 6 000₸ per unit |
| Installation of winter (slot) ventilationventilation mode | from 7 600₸ per unit |
| Thermal imaging inspection of windowsdraught detection | from 9 000₸ per job |
| Master's visit and inspectionwithout repair order | from 3 600₸ per job |
| Elimination of draughtssealing | from 3 500₸ per sash |
| Window handle replacementnew hardware | from 2 750₸ per unit |
The price is fixed in the order after measurement.Measurement and consultation are free.Payment after installation: cash, card, or Kaspi.
Book a serviceFacts about the company that matter when choosing a window care specialist.
we work across Kazakhstan
for work and replaced components
we work daily
installation: cash, card, or Kaspi
the price is fixed after measuring
consultation and measurer visit
of Kazakhstan where you can order
plastic, wooden, aluminum
Four steps from request to result check.

You leave a request, we reply on WhatsApp within 5 minutes and agree on a convenient time.

The master arrives, inspects the windows and determines the list of necessary works.

Performs adjustment, lubrication, drainage cleaning and other agreed works.

The customer opens and closes the sashes themselves, checks smoothness by ear and touch, absence of drafts and jamming after the master's visit.
Good to know
We handle window maintenance in Aktau as a direct contractor with our own fitters, not through an agency. We repair and adjust windows, replace seals on KBE, Rehau, VEKA and Provedal profiles, swap glass units within a day, and fit mosquito screens and window locks. Measuring and consultation are free, and you pay only after installation.
Window maintenance is more than a repair call once a draught appears. It is a set of small jobs that keep the leaf, the gasket and the fittings working all year round.
In a windy, salty coastal city like Aktau, a full inspection once a year before the cold season and a light hardware check every six months keeps sashes closing tightly. Window maintenance in Aktau follows the same rhythm, with the annual visit timed to the local weather. Salt air dries out rubber gaskets faster than inland climates, and wind-driven sand works into hinges and locking cams, so lubrication matters more here than in a sheltered region. The annual visit covers the leaf, the gasket, the mounting joint and the glass unit, while the six-month visit is usually just a wipe-down and a drop of lubricant on the moving parts. The best moment to book is a calm, dry week in autumn — a fitter can adjust the sash and swap a tired gasket before the wind season stresses both.
Coastal glazing runs on a different wear schedule from inland units — wind, sand and salty sea air act on the seal and the hardware in ways a dry continental climate never does.
Salt air dries out the weatherstripping and fine sand works into the hardware, so a unit that closed tightly two seasons ago starts letting a draught through at the sash edge. The Caspian breeze carries abrasive dust that settles in the hinge channels and the tilt mechanism, while the salt film pulls moisture out of the rubber and leaves it hard and slightly shrunken. Ultraviolet light from long summer days then breaks down the surface until it stops springing back. The result shows up slowly: first a faint whistle, then condensation on the inner glass. A draught along the whole opening line usually means the seal has hardened, while a leak at one corner points to a sash that has dropped out of alignment.
Most tired-looking units do not need to be swapped out whole. A fitter first identifies which part actually gave way, and only then decides whether the job is a repair or a replacement of one component.
| Symptom | Likely cause | What we do |
|---|---|---|
| Sash catches at the bottom | Alignment has drifted | Adjust the hinges |
| Draught along the closing side | Rubber lost its spring | Fit a new gasket |
| Handle turns, nothing locks | Locking point gave way | Replace the fitting |
| Sash square but draughty | Worn gasket, loose hinge | Adjust, then re-seal |
A unit with condensation or a milky film between the panes cannot be repaired — the sealed cavity is gone, and we swap it out, with urgent work available within a day. The glass itself is usually sound; it is the perimeter barrier that lets moisture in, and once that line breaks no amount of drying brings the clarity back. Mist that clears by itself is usually room humidity on the inner pane, so check whether the fog sits between the panes before ordering anything. On a coastal facade salt air speeds up that breakdown, which is why units facing the sea cloud sooner than sheltered ones. Our glass unit swap carries a three-year warranty.
Some checks an owner can run in five minutes, and that alone helps a fitter understand the problem before the visit is even booked.
Cleaning and lubricating the hardware is safe to do yourself, but once a leaf has dropped, a hinge has failed or a glass unit has fogged, our fitters take over, because those jobs need the right part and a proper alignment. A dropped leaf pulls the gasket away along one side, and no amount of rubber renewal fixes that until the geometry is reset. We carry fasteners and hinges for plastic, wooden and aluminium profiles, so adjustment in Aktau is done in one visit rather than two. A correct adjustment leaves the leaf sitting evenly in the frame with the handle turning smoothly through its full travel, so ask the fitter to show you the leaf line before they pack up.
When diagnostics show that a new component is needed, it helps to know exactly what goes onto your unit and which options fit your profile and your task.
| Part | What we check | Timing |
|---|---|---|
| Seal | Profile groove, sash alignment | Same visit |
| Glass unit | Desiccant, spacer, fogging | Urgent — within a day |
| Fixings | Bracket wear, anchor hold | Same visit |
| Sash hardware | Hinge play, corner pressure | Same visit |
Ordering is simple: you describe the problem, we arrive for a free measuring visit, agree the scope and lock the figure in your order, and you pay once the work is finished.
We give a one-year guarantee on repair work covering both labour and replaced parts, three years on glass unit replacement, five years on installation and one year on mosquito screens. The terms differ because the jobs differ: a seal or hinge swap is a smaller intervention than a full fitting, and a sealed unit carries its own manufacturer-backed period. We handle everything directly rather than passing it to a third party, so a claim goes back to the same team that did the job. Keep the sheet the fitter leaves with you, because cover is tied to the parts listed there, and it turns any later claim into a single message rather than a search for paperwork.
Coastal care comes down to a short list — catching a draught early, reading the signs correctly and knowing when a part has reached its end.
What the service includes, how often it is needed, hardware, seal, double glazing
Konstantin Selenenkovsenior mosquito screen specialist, 10 years in the tradeOnline · replies within 5 minutes
Ask a questionServicing includes inspection, cleaning and lubrication of hardware and seals, and seasonal adjustment of the sashes. Replacing the seal, handles, double glazing or repairing a sash are separate jobs and are priced based on the actual work.
It is regular maintenance, not a repair after a breakdown. Seasonal prevention helps spot wear on hardware and seals in time, before the window needs serious repair.
In the local climate, hardware should be cleaned and lubricated at least once a year, and street-facing windows more often. Sand and dust speed up wear, so it is best not to put off prevention until the first squeaks.
Yes, that is usually how it works: the technician arrives with tools and supplies, and the scope of work is determined after inspecting the window. They confirm the exact set of works after inspecting the window.
Fogging between the panes means the seal is broken, and such double glazing is replaced rather than repaired. The sash can stay in place; the technician will take measurements and install new double glazing.
Wooden windows are serviced too: sashes are adjusted, hardware is lubricated, seals are renewed and the closing pressure is checked. The scope of work depends on the condition of the window and the type of hardware.
Thank you. We will call you back within 10 minutes!
Your order number is on the receipt or in the SMS. Choose where to leave your review.
Write a review on WhatsApp