Window painting
Surface preparation and coating. Price from 8 100 ₸ per window.


Restoration of the frame, sash, glazing bead, glass and hardware without replacing the whole block.
A wooden window consists of a frame, sash, glazing bead, glass and hardware. Repair restores these elements to working condition: the sash closes again, the glass stays in the glazing bead, handles and latches work.
The master assesses the condition of the wood and decides what to do: restore the area or replace the part. Restoration includes sanding and painting, repair fixes a specific fault.

window painting with preparation
warranty on works and components
measuring and consultation
From draughts to cracks in wood: every fault has its solution.

Swedish insulation seals the perimeter and eliminates draughts.
The damaged wood area is cut out and replaced with new.
The sash is adjusted on site so it closes again without effort.
The glazing bead is replaced, the glass is fixed back in the frame.
Sealing the joints removes moisture between the frames.
Vent repair restores the sash movement and tight fit.
Filling and painting restore the frame surface.
Types of work: from painting to balcony block repair.
Preparation and application

Sanding, filling and painting the frame.
Glass and installation

New glass is inserted into the frame and fixed with glazing bead.
Handles, latches

Replacement and adjustment of hinges, handles, latches.
Inter-frame

Installation of inter-frame seal around the sash perimeter.
Swedish technology

Sealing around the perimeter eliminates draughts.
Complete block

Repair of the wooden balcony block as a whole.
Services and units of measurement; the price is fixed after measuring.
| Type of work | Price |
|---|---|
| Wooden window restorationsanding and painting | from 18 000₸ per m² |
| Wooden window paintingsurface preparation and application | from 8 100₸ per window |
| Wooden window frame repairfixing frame faults | from 16 000₸ per job |
| Wooden window repair and insulationfull scope of window works | from 28 000₸ per window |
| Wooden balcony block repaircomplete block | from 53 500₸ per unit |
| Wooden window hardware replacementhandles, latches | from 1 150₸ per unit |
| Wooden window insulation using Swedish technologysealing around the perimeter | from 4 200₸ per linear metre |
| Installation of inter-frame sealaround the sash perimeter | from 2 800₸ per window |
| Broken glass replacementglass and installation | from 8 000₸ per m² |
| Master's visit and inspectionwithout repair order | from 3 600₸ per job |
The price list shows units of work; the final scope is determined by the window's condition.Ask the master how additional work will be calculated if it is identified during the repair.The price list indicates the unit for each rate: sash, linear metre, or element.
Book a measuring visitCompany facts: warranty, schedule, payment, and free measuring.
on work and replaced components
on window installation
on double glazing replacement
daily 09:00–22:00
cash, card, or Kaspi
and consultation
to a message
of Kazakhstan
From request to checking the result.

You leave a request, and we agree on a convenient visit time.

The master agrees the scope on site: shows defects and discusses with you what will be done before starting work.

Performs the repair on site using the necessary components.

You check the result: the sash closes, the glass holds.
Good to know
Wooden window repair in Semey is done by our own crew, not a middleman. We fix sagging sashes, replace worn seals on frames of any make, stop draughts and swap glass units, then hand the window back with a 1-year warranty on the work and replaced parts. Measuring and consultation are free.
Repair costs less and takes less time than replacement when the casing and the moving leaf are intact. The call rests on the condition of the wood, the geometry of the leaf and the hardware, not on age.
We repair a wooden window when the casing and the moving leaf are sound and the fault sits in the seal, the hardware or a sagging hinge. A leaf that drags on the sill, a handle that no longer pulls it tight, a draught along the rebate — these are adjustment jobs, not joinery jobs. Our crew tightens hinges, shims the casing back into line, swaps worn seals and re-fits loose glazing beads, so the unit keeps its original wood and its original look. Wooden window repair in Semey usually takes one visit when the parts are already on the van. A unit that has dried out and opened hairline gaps is still worth fixing, because those gaps close with sealing and adjustment rather than fresh stock.
The work runs from an inspection to a tightened sash, a fresh seal, sanding and insulation. Most of it happens on site with the frame still in the wall, so you keep your window and your plaster.
Most repairs of this kind are done with the casing left in the wall, and a single window is usually finished within one visit. Our crew works on the sash, hinges and seal from inside the room, so there is no need to cut the casing out of the opening. Leaving the frame in place keeps the reveal and the plaster intact, which is why a repair avoids the finishing work a full replacement would trigger. Timber that has swollen or dropped slightly is planed and re-set rather than pulled out. On older houses in Semey the opening is often uneven, and re-hanging a sash in a casing that already fits the wall is faster and cleaner than fitting a new one. If the casing itself is rotten through, we say so on the spot instead of repairing around it.
Before packing up, our crew opens and closes the sash, checks the seal all round and confirms the window latches without force. We run a hand along the gasket line to feel for gaps, then look at the hinge side for any drop that appeared while the new seal was compressed. A sash that still needs a shove to close will pull the new seal loose within a season, so the final check matters as much as the repair itself. If the latch catches high or low, the hinge is adjusted again before we leave. You get a short walk-through of what was changed and how to air the window without straining the new gasket.
Cold draughts in winter almost always come from a worn seal and loose sash pressure, not from the frame itself. Insulation starts with a new gasket and a proper adjustment, not with film taped to the glass.
| Where the draught comes from | What we check | What we do |
|---|---|---|
| Worn strip in the channel | Channel width and depth | Fit a matching gasket |
| Loose closing pressure | Hinge and lock alignment | Adjust the leaf |
| Gap at the casing edge | Casing-to-wall joint | Seal the joint |
| Worn hinges | Play in the hinge pin | Replace the hinge |
We insulate a window by sealing the gaps, adjusting the sash pressure and checking the glass unit seating before the cold sets in. We replace the seal in windows of any make, including KBE, Rehau, VEKA and Provedal profiles, matching the gasket to the groove in your casing rather than to a label on the roll. A strip that is too thick stops the leaf closing flush and wears out faster, so groove width matters more than the brand name. In our practice, a profile cut for a 4 mm groove will not sit correctly in a 6 mm one, and the draught returns within a season. Cleaning the rubber with a damp cloth and oiling the hinges twice a year keeps the adjustment far longer than leaving the window untouched until it whistles.
Measuring and consultation cost nothing and happen at a time that works for you: the measurer takes the sizes and helps choose the design, the mesh and the fixings for your casing.
Our measurer arrives when it is convenient for you, takes the sizes and helps choose the design, the mesh and the fixings on the spot. Timber sashes vary more than plastic ones — a casement that has settled over decades is rarely square, and the profile depth differs from block to block — so the crew measures each opening separately rather than ordering a standard panel. The visit covers the whole job: you discuss the cloth (fiberglass, Ultravue, Pet Screen, anti-dust or Poll-Tex), the colour and the way the guard will sit against the casing. The price is fixed in the order after measuring, so the figure you agree at the visit is the figure you pay once the work is done.
| Fixing | Where it fits | How it holds |
|---|---|---|
| Z-brackets | Deep wooden profiles, upper floors | Clamp the panel, tool-free removal |
| Pins (plungers) | Shallow rebates, small sashes | Spring-loaded, quick to lift out |
| Magnets | Light guards, easy-access windows | Pull apart by hand, no drilling |
A repair is only as good as what happens after the specialists leave. This section covers what the warranty actually includes, when money changes hands, and how to tell a proper team from a random fitter.
We give a 1-year warranty on window repair that covers both the labour and the parts we replace, and you pay only after the work is done — by cash, card or Kaspi. The price is fixed in the order after measuring, so the figure you agree to is the figure you settle. Every replaced part is written into that order sheet: hinges, seal, fittings, whatever the frame needed. A wooden window repair in Semey is finished when the leaf closes evenly and the seal sits tight, and that is the moment we hand over the paperwork. Keep the order sheet with your window documents — a claim then takes one message, not a search through old receipts. We reply on WhatsApp within five minutes and work seven days a week.
A quick recap of the decisions that matter most before you book a repair, from judging the frame to understanding what the warranty covers.
Restoration, double glazing replacement, sash adjustment, wood care
Konstantin Selenenkovsenior mosquito screen specialist, 10 years in the tradeOnline · replies within 5 minutes
Ask a questionYes, local rot can be treated: the damaged area is cut out, healthy wood is inserted, filled and treated with a protective compound. If the rot has gone deep into the frame, the technician during the free measuring visit will advise whether to replace the part or the window.
Repair restores the window's working properties: eliminates draughts, sagging, and replaces worn parts. Restoration additionally brings back the appearance and historical geometry: filling, profile fitting, painting.
Yes, if the frame and sash are sound, the double glazing is replaced without changing the wooden elements. The technician removes the glazing bead, takes out the old glass and installs the new one, then checks the seal.
Yes, adjustment usually helps: tightening or repositioning the hinges, trimming the swollen edge, replacing the fixings. If the misalignment is severe and the wood has warped, the technician on site decides whether adjustment is enough or the sash needs to be rehung.
Yes, the seal compresses and cracks over time, causing draughts. It should be replaced when it becomes hard or no longer fits tightly, usually every few years, depending on the window and care.
Regularly clean and lubricate the seal, touch up damaged areas and check the hinges. In the dry climate of Semey, wood especially needs protection from drying out and temperature changes.
Thank you. We will call you back within 10 minutes!
Your order number is on the receipt or in the SMS. Choose where to leave your review.
Write a review on WhatsApp